DIRECTIONS * Shake Well Before Using* 1. Bypass FILTER MEDIA before adding FIX-A-LEAK to water. Sand filters: set filter valve to recirculate. Other types: remove cartridges or DE elements from the filter tank. Then proceed. 2. With pump running, add FIX-A-LEAK slowly through skimmer or in front of any other suction intake. 3. After adding FIX-A-LEAK adjust suction to main drain. If this is not possible, the vacuum cleaner could be used alternatively, simply by placing the vacuum in deepest part of pool and connect to normal vacuum connection. Set filter valve to normal vacuum position. 4. FIX-A-LEAK is very heavy and will sink to the lowest point rather quickly. It must be stirred back into suspension, either manually using a pool broom or mechanically with a automated pool cleaner every 4-6 hrs. during circulation of water. 5. Continue to recirculate water until the leak has stopped. 6. Mark level of water in pool and check for 2-3 days to determine if the leak has stopped. 7. After the leak has stopped and given the proper time to cure (24-48 hrs.) you may return to normal filtration. Sand Filters: Set filter valve to filter and resume normal operation. Backwash out unused FIX-A-LEAK as required. Other Types: Reinstall filter into tank and resume operation. Rinse out unused FIX-A-LEAK from filter as required. *NOTE* Never let cartridges or DE elements be left to dry before they are cleaned. 8. Treatment can be repeated if necessary.